Veterinary & Kennel Epoxy in Los Angeles.

Residential pricing for veterinary and kennel epoxy in the Los Angeles market typically runs between the ranges quoted on our service pages, with the exact number determined by substrate condition, finish system, and square footage. Commercial pricing is always project-specific.

It depends on your slab, so we price it in person. The walkthrough costs nothing and takes about half an hour. The next morning you get a fixed price by email, and that number holds through the pour.

On most homes we are in and out in two to three working days, and that covers grinding, crack repair, the pour and the topcoat; the walkthrough and moisture test happen before we book the days. Larger residential floors and commercial work run four to fifteen days.

You can walk on it 24 hours after the last coat of polyaspartic goes down. Give it 72 hours before vehicles or heavy equipment roll on it.

The coating holds because it bonds chemically with the substrate. That is why the prep matters so much, and why a properly prepped residential floor is built for lifetime adhesion.

The polyaspartic topcoat can be refreshed at the 8-to-12-year mark on heavy-use residential floors. The base resin stays bonded. Commercial systems are spec’d to traffic and chemistry; typical lifespan is 10-25 years on the resin layer.

Any color works in metallic epoxy, since the pigments mix across the full spectrum. Just-black and mother-of-pearl are both floors we have poured.

Quartz has 14 standard colors, and we can mix a custom one if none of them fit. Flake works the same way: start from a pre-blended pack or build your own blend. On decorative concrete, color is either mixed into the pour or stained on after it cures.

It ends with you and us on the floor together for a final inspection, and a written job spec in your hands before the crew leaves. Getting there takes four stages: the walkthrough and a moisture test, then diamond grinding to CSP-3 with any crack repair, then the pour and broadcast, and last the polyaspartic topcoat.

The two layers age differently. The base resin is bonded to the substrate and stays put for the life of the floor. The topcoat is the part that takes the foot traffic and the tires, so that is the layer we look at again down the road and refresh when the gloss fades.

Day to day it cleans with a damp mop, which is all the upkeep the system asks for. You will not be buying wax or booking a resealing crew.

Most contractors in LA do one thing. We are licensed and trained in three: resinous coatings, decorative concrete and structural slabs, so a cracked slab under your coating does not get handed off to someone else. The owner walks each job and shows up on prep days, and the prep itself (grind to CSP-3, HEPA-vacuum, grind again) never gets cut.